PVDC Plastic Glues S1001 Glue used for special hydrophilic antirust
Product Type S1001
S1001 is one of our PVDC products. It is able bear erosion and
burning. Also it has strong adhesion and low vapor penetration. Its
chemical and physical properties are more stable than
chloroethylene’s. Coated film is highly obstructive and excellent
plasticity. It is the same with lacquer of crylic acid. It accords
with the healthful standards of food, and the coated films are
accord with the standards of FDA.
There is innocuity, insipidity, no pollution, uneasy to burn or
burst. So it is easy to transport.
It can be directly coated to the surface of steel which has rust or
not, has hard oxide or old lacquer. Huge steel component with
complex figure of which rust is difficult to remove shows its
particular advantage. Working procedure is predigested, labor
tension lightens and product cost debases. It makes for
civilization and safety.
Coated film is easy to dry, firm, strong to adhere, able to bear
acid, alkali, salt water, bad macroclimate and 500℃ of temperature.
It can be used in wet condition and with all kinds of other top
It is the most distinct peculiarity that kinds of organic or
inorganic solvent or thinner, such as dimethylbenzene and gasoline
etc, are strictly forbidden to mix in it. It should stir to
equality before use. Water can be mix up if it is too dense.
Product can be coated in brushing, rolling, dipping or spraying.
According to rust, heavily coat to heavy rust and lightly coat to
light rust. Tools, equipments and containers can be washed by
water, and must not by organic solvents. Surface oil, sand, dust,
sundries and unstable rust should be removed before coating. The
thickness of rust is commonly less than 100 micrometers. If it is
more than 100 micrometers, it should be coated one more times.
Large area can be coated. One kilogram of product can coat about 12
square meters. Anticorrosive effect or life is about 2 times of
common antirust. 40% of cost can debase.
Specification of Glue
Appearance milk white liquid
Solid content（weight）﹪ ≈ 50﹪
Viscosity 25℃ 10
Vitrification temperature 50℃
Lowest temperature to become film 16℃